Precision Reducing Sleeves and Bushes

A full range of Precision Reduction sleeves for Hydraulic and Hi-Grip chucks are available.
 
Also in the range are plain and headed sleeves mainly for use directly into lathe turrets or VDI tooling.
 
Specials are also available, please contact our technical department.
Download range

Precision Reducing Sleeves and Bushes

  • Hydraulic Reduction Sleeves

    Designed for use in Hydraulic Chucks.
    Available in outside diameters 12, 20, 25 and 32mm with both metric and imperial bore sizes.
    Precision ground with a maximum run out of 0.003mm

    Download PDF
  • Precision Milling Chuck Sleeves

    Designed for use in Precision Milling Chucks.
    Available in outside diameters 20 and 32mm with both metric and imperial bore sizes.
    Precision ground with a maximum run out of 0.003mm

    Download PDF
  • Reduction Sleeves

    Available in diameters 20, 25, 32, 40, 50 and 60mm
    Clamping is by means of lock screws within the sleeve

    Download PDF
  • Reduction Sleeves Headed

    Primarily for E2 boring bar holders
    Available in diameters 25, 32, 40, 50, 60 and 80mm
    Clamping is by means of lock screws within the sleeve or through clamping depending on the design

    Download PDF
  • Split Reduction Sleeves Headed - Short

    A range of sleeves where one side of the bush is split to help reduce tool vibration.
    Available in diameters 20, 25, 32, 40, 50 and 60mm
    Clamping is by means of lock screws within the sleeve or through clamping depending on the design

    Download PDF
  • Reduction Sleeves Headed - Short

    Primarily for E2 boring bar holders
    Available in diameters 25, 32 and 40mm
    Clamping is through clamping on all sizes.

    Download PDF
  • Reduction Sleeves - Morse Taper

    A range of plain and headed sleeves for Morse Tapers 1, 2, 3, 4 and 5.
    Available in 20, 32, 40, 50 and 60mm diameters
     

    Download PDF