Tapping Collets

 
A range of collet and quick change systems system are available specifically for holding taps
 
We have a full range of DIN 6499 ER tapping collets both solid and tension type.
 
Also covered is the quick change tapping system with both solid and clutch type adapters.
 
DA (Double Angle) and TG (Tremendous Grip) tapping collets are also available.
 
The range of  DIN, ISO, JIS and ANSI tap shank / square specifications can be accommodated.

Tapping Collet Systems. (ER, Quick Change)

  • ER Collets - DIN6499 Solid Type

    A full range of  ER collet sizes from ER11 to ER50 is available specifically for machines capable of rigid tapping or using Synchro tapping systems.
     
    Shank diameters from 2.0 mm up to 32mm can be clamped. The collet has an internal square to allow positive drive of the tap.

  • ER Collets - DIN6499 Tension Type

    A full range of collet sizes from size 12 to size 40 is available specifically for machines without rigid tapping facilities. 
     
    The design allows between 5 and 15mm of axial movement during the tapping cycle.
     
    Shank diameters from 1.4 mm up to 17mm can be clamped. Positive drive on the square is achieved by four adjustable screws.

  • Quick Change Tap Adapters - Solid Type

    A range of adapters to suit the quick change system. The system has a positive drive to accommodate a range of DIN, ISO, JIS and ANSI taps dependenton the tap shank diameter and across flat sizes.
     
    There is a series of adapter sizes to suit a tapping range. Tap shank diameters from 2.5mm up to 36mm can be accommodated.
     
    These adapters can be fitted to either solid or tension / compression type toolholders.

    Download PDF
  • Quick Change Tap Adapters - Slipping Clutch Type

    A range of adapters to suit the quick change system. The system has a positive drive to accommodate a range of DIN, ISO, JIS and ANSI taps dependenton the tap shank diameter and across flat sizes.
     
    Also built in is a slipping clutch system designed to prevent tap breakage.
     
    There is a series of adapter sizes to suit a tapping range. Tap shank diameters from 2.5mm up to 36mm can be accommodated.
     
    These adapters can be fitted to either solid or tension / compression type toolholders.

    Download PDF
  • End Mill to Quick Change Solid

    Enables a standard End Mill Adapter to hold the quick change tap adapters. 
     
    Gives added flexibility due to the large range of End Mill type toolholders available on the majority of taper systems.
     
    For End Mill bores 16, 20, 25 and 32mm - tap shank diameter 3.5 to 18mm.
     
    Solid type only (No tension or compression)

  • End Mill to Quick Change Tens + Comp

    Enables a standard End Mill Adapter to hold the quick change tap adapters. 
     
    Gives added flexibility due to the large range of End Mill type toolhoders available on the majority of taper systems.
     
    For End Mill bores 16, 20, 25, 32 and 40mm - tap shank diameter 3.5 to 25mm.
     
    Tension and compression type.

  • Rubberflex Tap Collet.

    A collet system used in specific types of tapping systems. Each collet type has a wide clamping range on the shank and provides a small amount of flexibility during the tapping cycle.